Partially Removing The Controller Eca To Access Other Parts - Toshiba TDP-P5 Service Manual

Partially Removing the Controller ECA to Access Other Parts

The controller ECA covers many of the internal components in the projector. The controller connects to
the formatter ECA with three flexible ribbon cables. When you lift the controller ECA, these ribbon cables
act as hinges to allow access to components beneath the controller ECA. The formatter ECA remains
connected to the optical engine allowing stable hinge action. Use this procedure to lift the controller ECA
and swing it out of the way while you access components inside the projector.
1 Remove the following items:
Lamp module (see page 7)
Top case (see page 9)
2 Remove the fasteners that secure the I/O shield to the bottom case and the controller ECA.
Place the fasteners aside. Each of the fasteners is also available in the hardware kit (see page
83).
3 Remove the I/O shield and the M1 connector shield from the controller ECA.
TDP-P5 Service Manual 16