Remove and Replace the Keypad
The keypad fastens to the inside of the top case. Pressing a key causes a conductive surface on the
bottom of the keypad to contact the controller ECA and register the activity. The keypad is a single
assembly. It includes the key set and two light pipes that conduct light signals through the top case from
the projector status and lamp status LEDs on the controller ECA.
1
Remove the top case (see page 9)
2
Gently peel the keypad away from the inside of the top case.
Assembly Notes
♦
Ensure that the three alignment pins on the inside of the top case fully engage the holes in the
keypad.
♦
Press the keypad down firmly to secure it in the top case.
TDP-P5 Service Manual
13