Touchpad Board - HP 17g Maintenance And Service Manual

TouchPad board

Description
TouchPad board
TouchPad cable
NOTE: This cable connects from the TouchPad board to the TouchPad click board.
Before removing the TouchPad board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the TouchPad board:
1. Disconnect the TouchPad cable from the TouchPad board (1).
2. Lift the conductive tape (2), and them remove the TouchPad board from the computer (3).
Reverse this procedure to install the TouchPad board.
Battery on page 32).
Optical drive on page
Bottom cover on page
34).
41).
Component replacement procedures
Spare part number
926531-001
926518-001
55