Access Control; Recording - Datavideo DVS-100 Instruction Manual

Unicast
Multicast
Decklink Output
Here you can use an output card from Blackmagic Design to decode the channel to HDMI or SDI. We
currently support all Blackmagic Decklink, mini monitor and mini recorder cards using the Desktop
video 10.8.4 or newer driver version.
You can setup multiple outputs if your card has more than one output or you are using multiple
cards. If your card features HDMI and SDI inputs you must use the Blackmagic Desktop Video Utility
to set the input type outside of the DVS-200 software.

Access Control

Here you can restrict what IP addresses can publish or playback using RTMP. In whitelist mode, only
the listed IPs can publish or playback, in blacklist mode all but the listed IPs can publish or playback.
You must enter the IP address followed by its abbreviated subnet mask, for example 255.255.255.0
is a 24-bit mask so is represented as /24. Please consult your IT department if unsure about these
settings.

Recording

Here we can enable recording, you have three options:
Always – Audio & Video
The software will record as soon as an input stream is detected and will stop recording when the
stream is stopped. Audio and video are recorded together.
Always – Audio Only
The software will record as soon as an input stream is detected and will stop recording when the
stream is stopped. Only audio is recorded.
19