Toshiba RAV-SM182UTP-UL Installation Manual page 21

 Energy saving
Set for the energy saving operation: Energy saving
operation, Set temp. range limit, Return back and
Saving operation.
1
Push the [ ˄ ] / [ ˅ ] button to select
"Energy saving" on the menu screen, then
push the " Set" [ F2] button.
2
Push the [ ˄ ] / [ ˅ ] button to select
the item to set.
3
Push the " Set" [ F2] button.
Item Function
1. Energy Perform the power saving
saving operation operation of the air conditioner.
2. Set temp. Set the temperature range limit of
range limit the remote control operation.
Set the function that changes the
temperature back to the specified
3. Return back temperature automatically if the
temperature has been changed on
the remote control.
Performs operation by
suppressing excessive heating or
excessive cooling through
automatic correction of the
4. Saving operation temperature set point.
* "No function" is displayed in
the case of a model for which
the saving operation cannot
be set.
CAUTION
Refer to the Owner's Manual supplied with the air
conditioner about "Energy saving operation", "Saving
operation".
39-EN
 Energy saving operation
Set for the power saving operation of the air conditioner.
1
Push the [ ˄ ] / [ ˅ ] button to select
"1. Energy saving operation" on the
"Energy saving" screen.
2
To start the Energy saving operation:
After setting "2. Energy saving ratio" and
"3. Energy saving schedule", push the
" " [ F1] button to select
"ON", then push the [ MENU] button.
To stop the Energy saving operation:
Push the" " [ F2] button to
select "OFF", then push the [ MENU]
button.
Energy saving ratio
Carry out the setting operation while the indoor unit is
stopped. (Turn off the air conditioning unit before starting
the setting operation.)
1
Push the [ ˄ ] / [ ˅ ] button to select
"2. Energy saving ratio" on the "Energy
saving operation" screen, then push the
" Set" [ F2] button.
2
Push the " %+" [ F1] /
" %-" [ F2] button to set the value.
The Energy saving ratio can be set within the
range from 50% to 100% by 1%. The lower
the value is set, the higher the power saving
effect becomes.
3
Push the [ MENU] button.
Setting" appears on the screen, then the
"
screen returns to the "Energy saving
operation" screen.
NOTE
• Cooling / heating performance may be reduced a
little because its power is saved during the Energy
saving operation.
• " " appears on the display when the Energy
saving operation is activated.
• The Energy saving operation cannot be set on the
Follower remote control when the dual remote
control system is used.
• The remote control may not be used for setting the
Energy saving operation depending on the settings
of the central control remote control or the outdoor
unit.
• The Energy saving schedule operation is not
available when the clock display is blinking (the clock
has not been adjusted).
 Remote controller switch
monitoring function
This function is available to call the service monitor
mode from the remote controller during a test run to
acquire temperatures of sensors of the remote
controller, indoor unit, and outdoor unit.
1
Push the [ ˄ ] / [ ˅ ] button to select
"4. Monitor function" on the "Field setting
menu" screen, then push the "
[ F2] button.
Push the [ ˄ ] / [ ˅ ] button to select
the code to check data.
2
Refer to the Installation Manual supplied
with the indoor unit or outdoor unit or
service manual for details about the check
code and data.
3
Push the [ CANCEL] button to return to
the "Field setting menu" screen.
� 20 �
Set"
EN
40-EN