Toshiba RAV-SM182UTP-UL Installation Manual page 20

 Swing type
* Select the louver swing type from the standard swing,
dual swing or cyclic swing.
Carry out the setting operation while the indoor unit
is stopped. (Turn off the air conditioning unit before
starting the setting operation.)
Before setting
1
Push the [ ˄ ] / [ ˅ ] button to select
"3.Louver setting" on the menu screen, then
push the " Set" [ F2] button.
2
Push the [ ˄ ] / [ ˅ ] button to select
"1.Swing type", then push the
" Set" [ F2] button.
3
Push the [ ˄ ] / [ ˅ ] button on the
"Swing type" screen to select the swing type.
Refer to the Owner's Manual supplied with the
indoor unit about the swing type.
4
Push the [ MENU] button.
Setting" appears on the display.
"
The unit selection screen appears when the
group control is used. Push the [
button on the unit selection screen to finish the
setting operation. " Setting" appears on the
display.
NOTE
• "No function" appears on the display for the models
not equipped with the Swing type setting.
• Push the [ CANCEL] button to stop the setting
procedure. No setting has been made and the
screen returns to "Louver setting".
37-EN
 Louver lock
* The direction of the louver can be locked individually.
Carry out the setting operation while the indoor unit
is stopped. (Turn off the air conditioning unit before
starting the setting operation.)
Before setting
1.Swing type
2.Louver lock
1
Push the [ ˄ ] / [ ˅ ] button to select
"3.Louver setting" on the menu screen, then
push the " Set" [
2
Push the [ ˄ ] / [ ˅ ] button to select
"2.Louver lock", then push the
" Set" [ F2] button.
3
Push the " Louver No." [
button to select the louver to set.
The display changes as follows each time the
button is pushed.
CANCEL]
Electrical control
3
box
Refrigerant pipe
4
Drain pipe
1
� 19 �
4
Push the [
the louver (wind) direction.
Push the [
upward. Push the [
downward.
F2] button.
5
Push the [
Setting" appears on the display.
"
The unit selection screen appears when the
group control is used. Push the [
button on the unit selection screen to finish the
setting operation. "
display.
NOTE
F1]
• "No function" appears on the display for the models
not equipped with the Louver lock setting.
• Push the [
procedure. No setting has been made and the
screen returns to "Louver setting".
• " " appears on the display when the Louver lock
function is used.
• Push the [
select the "Not locked" setting as the louver direction
to release the lock.
• Condensation may occur if the louver is locked in the
position (4) or (5) while cooling.
2
˄ ] / [ ˅ ] button to select
˄ ] button to move the louver
˅ ] button to move it
MENU] button.
CANCEL]
Setting" appears on the
CANCEL] button to stop the setting
˄ ] / [ ˅ ] button repeatedly to
38-EN