Table of Contents
Advertisement
Ringing from outside and operating
the machine remotely
With remote access you can:
listen to (and erase) messages and memos
listen to OGMs and record new ones
leave a message in a specific mailbox
switch the machine to answer on or off
set OGM1 or OGM2
You need to use:
a phone with Tone dialling; or
a Tone Dialler. But if the seal between the Tone Dialler and the mouthpiece
isn't perfect, you won't get perfect results.
What you need to know before you start
For most functions you'll need to enter your security code. Your security
code is set to 125 but you can change it: see below.
If your phone lets you, send long tones, not short ones.
Give the machine time to respond but don't leave longer than 15 seconds
between button presses. Otherwise you'll be cut off.
The machine beeps twice when it receives a command.
Your security code
Your security code is set to 125 but you can change it. Never change it to
the emergency codes 112 or 999.
ANSWERING MACHINE - REMOTE ACCESS
To check it
1 Ensure the Message Display and Answer Light is on. If it isn't,
press On/Off.
2 Press Repeat. Your code will be spoken. It is set to 1 2 5 during
manufacture.
To change it
The machine will call out the settings as you go through.
1 Hold down Repeat until you hear a beep.
2 Press OGM1 or OGM2 to change the first digit. Then press
Repeat.
3 Repeat step 2 to change the second and third digits.
After 15 seconds, the machine will call out the new code.
If you have a power cut and the battery is low, the code will change
back to 125.
To leave a message without waiting for the whole of the
OGM to be played
1 Call your number.
2 During the OGM, press (#) and leave your message after the beeps.
1 1
Advertisement
Table of Contents
