Table of Contents
Advertisement
To set either OGM1 or OGM2
Hold down On/Off for 2 seconds until you hear a beep.
If the Answer light is on, OGM1 is set.
If the Answer light is flashing, OGM2 is set. (OGM2 doesn't normally let the
caller leave a message).
To switch the answering machine On or Off
Press On/Off briefly.
If the Message Display is on, the machine is on and ready to answer.
If the Message Display is off, the machine is off.
If the machine is off, it'll 'answer' calls after 15 rings and play the
pre-recorded OGM2. (Most callers will hang up well before 15 rings).
This lets you ring in and switch the machine on: see page 13.
Note: If the answer light is flashing then OGM2 is set to change this
to OGM1 please refer to OGM section.
To listen to your messages
(a) At the base unit
If you have any messages, the Message Display shows the total.
Press Play/Stop.
To PAUSE, press Memo. To continue, press Memo again.
To SKIP to the next message, press Skip.
To SKIP TO THE PREVIOUS message, press Repeat.
If you do not wish to hear the day/time announcement during message
playback, press On/Off whilst listening to the messages. Press again to
restore the day/time announcement.
ANSWERING MACHINE - BASIC USE
To ERASE a message, press Erase before it ends. (To make sure you've
heard it all, it's best to skip backwards (press Repeat) and erase it when
you hear it again).
To ERASE ALL MESSAGES: after playing them, hold down Erase until
you hear a beep.
To STOP, press Play/Stop.
An 'erased message' isn't erased immediately. It's erased after the
machine says 'end of messages'. Up until this time you can still hear an
'erased message' again.
Mailbox messages and memos are played last.
To hear only the new messages, not the old ones, hold down Play/
Stop until you hear a beep.
Don't let the memory become full - erase the messages you don't need
to keep.
The longest message the machine accepts is 2 minutes. It'll send the caller
a warning beep just before this time is up.
(b) From the handset
1 Press SCREEN and wait for In Use light to stop flashing.
2 Press ( ) button. After 2 beeps, message playback will begin.
To REPEAT a message, press (0) button during following message
announcement.
To STOP playback at any time, press ( ) button.
3 After announcement "end of messages", press SCREEN and ensure
In Use light goes out.
9
Advertisement
Table of Contents
