Table of Contents
Advertisement
Tones or end of call signals after
messages
On some systems, particularly cable telephone networks, you may hear short
periods of tone or 'end of call' signals after playing back messages. This can
be quite normal but if it is a cause for concern, please contact your local
telephone service provider who may be able to make an adjustment to your
particular telephone line.
If the memory's full
If the memory's full, the machine will answer after 15 rings and play the OGM2
that it comes with to the caller.
To check if the memory is full, hold down OGM 2 and release immediately
you hear a beep.
If the machine:
Beeps again and plays OGM 2, the memory isn't full.
Beeps 3 times and says "full memory", erase messages to make room
for new ones.
ANSWERING MACHINE - BASIC USE
When you're at home, you can listen to callers leaving a message.
If you're at the baseunit
'_ _' will flash on the message display
to speak to the caller, pick up the handset and press Talk/End.
to refuse an incoming message, press Play/Stop on the base unit.
If you're away from the baseunit
1 To listen in, press SCREEN on the handset.
2 You can now:
accept the incoming message by pressing SCREEN again; or
speak to the caller by pressing Talk/End; or
refuse the incoming message by pressing Talk/End twice.
To leave a memo (like leaving a note
for someone you live with)
Speak 20cm from the front of the machine.
Hold down Memo - speak after the beep - then release Memo when
your message is complete.
Your memo is added to the Message Display total.
To listen to memos, press Memo. If there aren't any memos you'll hear
"no messages".
1 0
Monitoring calls
Advertisement
Table of Contents
