Table of Contents
Advertisement
Operation
Starting up the projector
1.
Plug the power cord into the projector and
into a power outlet. Check that the POWER
indicator light on the projector lights
orange after power has been applied.
•
Please use the original accessories (e.g.
power cable) only with the device to
avoid possible dangers such as electric
shock and fire.
•
If Direct Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically after
the power cord has been connected and power has been applied. See
"Direct Power On" on page 59
•
If Signal Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically
when VGA signal is detected. See
details.
2.
Press
on the remote control to start the
projector. The POWER indicator light
flashes and stays green when the projector
is on.
The start up procedure takes about 10-20
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Use the focus ring to adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for
approximately 90 seconds before energizing the light.
3.
If the projector is activated for the first time,
select your OSD language following the on-screen
instructions.
4.
If you are prompted for a password, press the
arrow keys to enter a six digit password. See
"Utilizing the password function" on page 28
details.
5.
Switch all of the connected equipment on.
6.
The projector will start to search for input signals.
The current input signal being scanned displays in
the screen. If the projector doesn't detect a valid signal, the message 'No
Signal' will continue displaying until an input signal is found.
Power on the projector or ON
I
I
for details.
"Signal Power On" on page 59
for
for
Operation
23
Advertisement
Table of Contents
