Table of Contents
Advertisement
5.
Press
/
6.
To save the setting, press MODE/ENTER. If you do not want to save the
setting, press MENU/EXIT.
7.
Press
to highlight Apply and press MODE/ENTER.
8.
Press MENU/EXIT to return to Network Settings page, press
highlight AMX Device Discovery and press
9.
Press MENU/EXIT to exit the menu.
Controlling the projector remotely through a web
browser
Once you have the correct IP address for the projector and the projector is on or in
standby mode, you can use any computer that is on the same local area network to
control the projector.
1.
Enter the address of the projector in the address bar of your browser and click
Go.
2.
The remote network operation page opens. This page (Crestron eControl)
allows you to operate the projector as if you were using the remote control or
control panel on the projector.
1
1
To switch input source, click on your desired signal.
to move the cursor and then press
The source list varies according to the connectors available on
the projector. ''Video'' stands for the Video signal.
/
to enter the value.
/
to select On or Off.
Operation
to
2
43
Advertisement
Table of Contents
