Troubleshooting
Indicators
High Temp Error
(Overheating)
(blue)
(orange)
Indicator status during normal operation
Indicators
Standby condition
(blue)
Warm-up in progress
(blue)
Cool-down in pro-
gress
Projection in pro-
gress
(blue)
c
•
Under normal operating conditions, the
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
Extended - Operation - Illumination
s
Wireless LAN indicator and status (EH-TW5650 only)
Status
The internal temperature is too high.
•
The lamp turns off automatically and projection stops. Wait for
about five minutes. When the fan has stopped, disconnect the
power cord.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s
•
When using at an altitude of 1500 m or more, set High Altitude
Mode to On. s Extended - Operation - High Altitude
Mode
•
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the elec-
trical outlet. Contact your local dealer or the nearest Epson repair
center. s
Status
When you press the
control panel, projection starts after a short wait.
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is warm-
ing-up.
All operations are disabled while the projector is cooling-down.
The projector enters standby condition when cool-down is com-
plete. If for any reason the power cord is disconnected during
cool-down, wait until the lamp has cooled down sufficiently
(about 10 minutes), reconnect the power cord, and then press
the
The projector is operating normally.
and
o
p.71
79
Remedy
p.71
Epson Projector Contact List
Remedy
button on the remote control or the
button on the remote control or the control panel.
indicators are off.
m
p.91
: Flashing
: Lit
: Off
: Flashing
: Lit
: Off