Dukane 6650WSSA User Manual page 68

Enabling Security [SECURITY]
This feature turns on or off the SECURITY function.
Unless the correct keyword is entered, the projector cannot project an image. (→ page 30)
NOTE: Your setting will not be affected even when [RESET] is done from the menu.
Selecting Communication Speed [COMMUNICATION SPEED]
This feature sets the baud rate of the PC Control port (D-Sub 9P). It supports data rates from 4800 to 38400 bps. The
default is 38400 bps. Select the appropriate baud rate for your equipment to be connected (depending on the equip-
ment, a lower baud rate may be recommended for long cable runs).
NOTE: Your selected communication speed will not be affected even when [RESET] is done from the menu.
Selecting the serial port [SERIAL PORT]
This sets which terminal on the projector will receive the serial control signals when operating the projector by remote
control from a commercially available HDBaseT transmitter (control signals for turning the power on and off, etc.).
There is no need to make this setting if not operating the projector by remote control (only sending video and audio).
PC CONTROL ��������� Control signals (RS232C serial communications) are received at the PC CONTROL terminal�
HDBaseT ���������������� The video/audio and control signals (RS232C serial communications) are received at the Ethernet/HDBaseT
port�
NOTE:
• When [HDBaseT] is set, the projector goes into the SLEEP mode regardless the setting for the standby mode (→ page 60) on
the on-screen menu is [NORMAL] or [NETWORK STANDBY]. Based on this, the projector can be powered ON by an HDBaseT
transmission device that is connected to the projector when the projector is in the standby mode. However, the standby mode
setting cannot be changed when [HDBaseT] is set.
• While [HDBaseT] is set for the SERIAL PORT, power consumption in the standby mode becomes not to satisfy the energy saving
regulation.
TIP:
• When controlling the projector using the LAN port, this works with either setting.
Turning On or Off Remote Sensor [REMOTE SENSOR]
Set the remote control sensors on the projector's front and rear panels and the HDBaseT remote control sensor.
The options are: ALL, FRONT/BACK, FRONT, BACK, and HDBaseT.
TIP:
• If the remote control system does not function when direct sunlight or strong illumination strikes the remote control sensor of
the projector, change another option.
• The remote control sensor on the back of the projector cannot be used when the separately sold cable cover is mounted on the
projector.
55
4. Using On-Screen Menu