Dukane 6650WSSA User Manual page 100

Design and manufacturing conditions for the stand
Please engage an installation service provider for the design and manufacture of the customized stand to be used for
portrait projection. Please ensure that the following are complied with when designing the stand.
1. Maintain a distance of at least 100 mm between the projector intake vent and the floor.
Do not obstruct the intake vent at the front of the projector.
2. Use the four screw holes on the bottom face of the projector to secure it to the stand.
Screw hole center dimension: 200 × 250 mm
Screw hole dimension on the projector: M4 with a maximum depth of 8 mm.
* Please design the stand such that the rear legs on the bottom face of the projector do not contact the stand.
The front legs can be turned and removed.
3. Horizontal adjustment mechanism (for example, bolts and nuts in four locations)
4. Please design the stand such that it does not topple over easily.
Reference drawings
* The drawing showing the dimensional requirements is not an actual stand design drawing.
(Unit: mm)
160 × 35 or greater
200
Notch
[Side View]
5. Installation and Connections
Screw holes for 4 - M4 use
Intake vent
[Front View]
Horizontal adjuster
87