Table of Contents
Advertisement
Setting items
Blend
Settings
Blend Fitting
Zone Black
*4
Level Adj.
*5 *6
Image Split
Image Flip
High Altitude Mode On/Off: Set to "On" when using the projector at an altitude of 1,500 m or
Filter Cleaning
Filter Box (Op)
Screen Aspect
Description
Configure the Edge Blending setting for the top, bottom, right, and left of
the screen respectively.
Left/Right/Top/Bottom: Set the Edge Blending effect for each position.
Edge Blending: Set "On" to set "Blending Range" or "Blend Start Pos."
Blending Range: Set the width where images are overlapped.
Blend Start Pos.: Set the start position from which images are
overlapped.
Blend Cursor: Displays the cursors at the start and end positions for edge
blending. When set to "On," the cursors are displayed during Blend
settings.
Start Pos. Color: Select the color of the cursor that indicates the start
position.
End Pos. Color: Select the color of the cursor that indicates the end
position.
Reset: Resets all of the Blend Settings values.
Finely adjusts the overlapped part.
Adjust: Specify a position in the overlapped area and move image pixels.
Use V/v/B/b to select the position to adjust. Press the ENTER key to
determine the position and use V/v/B/b to move the image pixels
vertically/horizontally so that neighboring images overlap.
Reset: Resets all of the Blend Fitting values.
Adjusts so that the overlapped part is not noticeably bright when a dark
image is displayed.
Select the correction zone "Adjust Zone 1" through "Adjust Zone 9," and
set the adjustment values.
Zone Fitting: Adjusts the area of each correction zone.
Adjust: Specifies the position of the marginal line of each correction
zone.
Select the adjusting position using V/v/B/b. Press the ENTER key to
determine the position and use V/v/B/b to move the image pixels
vertically/horizontally so that the area of each correction zone is adjusted.
Reset: Resets all of the Zone Fitting values.
Black Level Adj.: Adjusts the brightness of each correction zone.
Reset: Resets all of the Black Level Adj. values.
Reset: Resets all of the Zone Black Level Adj. values.
Off/Left-side Area/Right-side Area: Divides the input signal from the
computer in half, and displays an enlarged image of the left-side or right-side
*7
area on the screen.
HV/H/V/Off/Auto: Flips the projected image horizontally and/or
vertically according to the installation method.
higher. Continuing to use the wrong setting may affect component
reliability.
Turns off the projector and cleans the air filter.
Installed/Not Installed: Set to "Installed" when using Projector Filter Box
(PK-F60FB1.)
16:10/16:9/4:3: For switching the display area to suit to the screen.
*8
37
Advertisement
Table of Contents
