Table of Contents
Advertisement
Setting items
With Static Signal
*11
Standby Mode
Quick Reboot
Direct Power On
Notes
*1: Set the IP address of this unit manually after connecting to the network. If this unit is not
connected to the network, the setting is not enabled.
*2: When connecting via HDBaseT, only the 100BASE-TX can be used for connection. When using
the LAN terminal of the main unit, you can connect with the 10BASE-T/100BASE-TX.
*3: When connecting via HDBaseT, the connection is at 9,600 bps. When using the RS-232C
terminal of the main unit, you can connect at 38,400 bps.
*4: For details on XTP Systems, refer to the product catalog or brochure from Extron Electronics.
*5: If the image input setting of the HDMI connection equipment is not correct, the brighter part
becomes too bright and the darker part becomes too dark.
*6: The image may not be adjusted properly depending on the type of input signal. In such a case,
adjust it manually to suit to the connected equipment.
*7: Select "Off" to avoid entering standby mode when there is no input signal.
*8: A change in signal may not be detected depending on the input image. If "With No Input" is set,
it takes priority.
*9: As the light is dimmed gradually, you may not notice any change in brightness.
*10:This varies depending on the "Light Output Mode" setting (page 26).
*11:When "Standby Mode" is set to "Low," the network and network control function cannot be
operated while the projector is in standby mode.
Description
*8 *9
Light Dimming
: If an image does not change for about 10
seconds, light output is gradually reduced (approximately 10% to
*10
15%
) from that set in the Light Output Mode. This setting provides
a convenient way to reduce power consumption. In addition, the light
automatically darkens slowly to approximately 5% of its light output if
the selected time ("5 min.," "10 min.," "15 min.," "20 min.," or
"Demo.") elapses with no change to input signal. While dimming the
light, the message "Light Dimming" appears. If you select "Demo.,"
the image will start to darken about 40 seconds later. When any change
in signal is detected, or an operation (remote control or control panel)
is performed, normal brightness is restored.
Off: The "With Static Signal" function is disabled.
Standard/Low: When set to "Standard," power consumption becomes
higher in Standby mode. For details, see "Power consumption
(Networked Standby Mode)" in "Specifications" (page 59).
Off/10 min./30 min.: After you turn off the power, the projector is in
standby mode for a quick start within the specified time (10 minutes or
30 minutes). The ON/STANDBY indicator lights in orange when the
projector is in standby mode. (page 49)
On/Off: When set to "On," you can turn the power on without going
to standby mode when the AC power cord is connected to a wall
outlet. You can also unplug the AC power cord without going to
standby mode when you turn off the projector.
You may unplug the AC power cord without going to standby mode.
35
Advertisement
Table of Contents
