TRENDnet User's Guide
Reboot your controller
Management > Maintenance
You may want to restart your controller if you are encountering difficulties with your
controller and have attempted all other troubleshooting.
There are two methods that can be used to restart your controller.
Turn the controller off for 10 seconds using the controller On/Off switch located
on the rear panel of your controller or disconnecting the power port, see
"Product Hardware
Features" on page 2.
Use this method if you are encountering difficulties with accessing your controller
management page. This is also known as a hard reboot or power cycle.
OR
Controller Management Page – This is also known as a soft reboot or restart and
steps are shown below.
1. Log into your controller management page (see
management
page" on page 10).
2. Click on Management and click on Maintenance.
3. In the Backup/Restore System Configuration section, click Reboot Controller.
4. Wait for the device to reboot.
© Copyright 2017 TRENDnet. All Rights Reserved.
"Access you wireless controller
Set idle timeout for users logged into controller management
Management > Maintenance
You can set the amount of idle time before automatic log out when a user is logged into
the controller management page.
1. Log into your controller management page (see
management
page" on page 10).
2. Click on Management and click on Maintenance.
3. In the field, enter the amount of time in seconds (120-3600) to specify the amount of
idle time before a user is automatically logged out of the controller management page
and click Apply.
TEW-WLC100P
"Access you wireless controller
16