Saeco Incanto HD8911/47 Manual page 28

English
28
Problem
There is water under the
machine.
I cannot activate the
AquaClean filter and the
machine asks for
descaling.
The AquaClean filter icon
does not appear on the
display after I replaced
the filter.
Cause
The type of milk used is not suitable
for frothing.
The drip tray is too full and
overflowed.
The machine is not placed on a
horizontal surface.
You have already replaced the
AquaClean filter 8 times. After you
have replaced the AquaClean filter 8
times, you need to descale the
machine.
The filter has not been replaced in
time after the AquaClean filter icon
flashed and the capacity dropped to
0%.
You did not install the AquaClean
filter during first installation, but after
having brewed approx. 50 coffees
(based on 100ml cups). The machine
has to be completely limescale-free
before you install the AquaClean
filter.
You did not activate the new or
replaced AquaClean filter in the
machine menu. Also after replacing
the filter, you need to confirm
activation in the machine menu.
You did not confirm activation in the
machine menu.
Solution
Different types of milk result in
different amounts of froth and
different froth qualities. We have
tested the following milk types
which proved to deliver a good
milk froth result: semi-skimmed or
full-fat cow's milk, soy milk and
lactose-free milk. Other types of
milk have not been tested and
may result in a small amount of
milk froth.
Empty the drip tray when the 'drip
tray full' indicator pops up through
the drip tray. Always empty the
drip tray before you start descaling
the machine.
Place the machine on a horizontal
surface so that the 'drip tray full'
indicator works properly.
Descale your machine first and
install the AquaClean filter. Always
activate the AquaClean filter in the
menu. Also do this when you
replace the filter.
Descale your machine first and
then install the AquaClean filter.
First descale the machine and
then install a new AquaClean filter.
After descaling, the filter counter is
reset to 0/8. Always confirm filter
activation in the machine menu.
Also do this after filter
replacement.
Descale your machine first. Then
activate the AquaClean filter in the
menu. Also do this when you
replace the filter.
Confirm the activation of the filter
in the machine menu. If the display
shows 'START CALC CLEAN', you
first need to descale the machine.
Remove the AquaClean filter
before descaling and reinsert it
afterwards.