Saeco Incanto HD8911/47 Manual page 27

Problem
Coffee is leaking from the
coffee dispensing spout.
The coffee is not hot
enough.
The machine grinds the
coffee beans, but coffee
does not come out.
The coffee comes out
slowly.
The frothed milk is too
cold.
The milk does not froth.
Cause
The machine is performing its self-
adjustment.
The brew group is dirty.
The coffee dispensing spout is
clogged.
The cups you use are cold.
The temperature is set too low.
Check the menu settings.
You added milk.
The coffee exit duct is blocked.
The grind is set to a too fine setting.
The brew group is dirty.
The coffee dispensing spout is dirty.
The coffee is grind too finely.
The brew group is dirty.
The coffee exit duct is blocked.
The machine circuit is blocked by
limescale.
The cups are cold.
The classic milk frother is dirty or not
assembled correctly.
English
Solution
Brew a few cups of coffee.
Clean the brew group.
Clean the coffee dispensing spout
and its holes with a pipe cleaner.
Preheat the cups by rinsing them
with hot water.
Set the temperature to 'high' in the
menu.
Whether the milk you add is warm
or cold, it always decreases the
temperature of the coffee to some
extent.
Clean the coffee exit duct with the
handle of the multifunctional tool
or a spoon handle.
Adjust the grinder to a coarser
setting.
Clean the brew group.
Clean the coffee dispensing spout
and its holes with a pipe cleaner.
Use a different coffee blend or
adjust the grinder.
Clean the brew group.
Clean the coffee exit duct with the
handle of the multifunctional tool
or a spoon handle.
Descale the machine.
Preheat the cups by rinsing them
with hot water.
Clean the classic milk frother and
make sure it is correctly
assembled.
27