Listening To A Cassette Tape (Tape 1 Or Tape 2) - Sharp CP-DP900S Operation Manual

Listening to a cassette tape (TAPE 1 or TAPE 2)

Before playback:
! For playback, use normal or low-noise tapes for the best sound.
(Metal or CrO tapes are not recommended.)
! Do not use C-120 tapes or poor-quality tapes, as they may cause mal-
functions.
! Before loading a tape into the cassette compartment, tighten the slack
with a pen or a pencil.
Playback is possible in TAPE 1 compartment as well as in TAPE 2.
1
Press the ON/STAND-BY button to turn the power on.
2
Open the cassette door by pushing the area marked " PUSH EJECT".
3
Load a cassette into the TAPE 1 or TAPE 2
cassette compartment with the side to be
played facing toward you.
4
Press the TAPE (1 2) button to select the cassette you want to
listen to.
5
Press the / button to start playback.
When playback is performed using the remote control, press the TAPE 1 or
TAPE 2 button.
To stop playback:
Press the (TAPE ) button.
Fast forward/rewind: (TAPE 2 only)
1 Press the (TAPE ) button, then press the TAPE (1
2 To advance the tape, press the / (
( ) button.
Caution:
! To remove the cassette, press the (TAPE ) button, and then open the compart-
ment.
! Before changing from one tape operation to another, press the
! If a power failure occurs during tape operation, the tape head will remain engaged
with the tape and the cassette door will not open. In this case, wait until the power
is restored.
03/11/28 CD-DP900S(E)2.fm
CD-DP900S
TAPE 1 TAPE 2
2) button to select TAPE 2.
) button. To rewind it, press the /
(TAPE ) button.
21
Sound control (See page 14.)
TINSEA032AWZZ
6