Table of Contents
Advertisement
Enhancing your system
CD-DP900S
The connection lead is not included. Purchase a commercially available lead as shown below.
Red
White
! Listening to the playback sounds from
VCR, DVD, etc.
1
Use a connection lead to connect the VCR, DVD, etc. to the VIDEO/
AUX IN sockets.
When using video equipment, connect the audio output to this unit and the video
output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX button.
4
Play the connected equipment.
Note:
To prevent hum interference, place this unit away from a television.
! To record on a tape
1
Insert a cassette in the TAPE 2 cassette compartment.
2
Press the VIDEO/AUX button.
3
Press the REC PAUSE (
4
Press the /
(TAPE 2 ) button.
5
Play the VCR, DVD, etc.
28
VCR, DVD, etc.
To the line
output sockets
White
Red
RCA lead
(not supplied)
) button.
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your
authorised SHARP dealer or service centre.
! General
Symptom
" The clock is not on time.
" Did a power failure occur? Reset the
clock. (Refer to page 15.)
" When a button is pressed, the unit
" Set this unit to the power stand-by mode
does not respond.
and then turn it back on.
" If the unit still malfunctions, reset it. (Refer
to page 29.)
" No sound is heard.
" Is the volume level set to "0"?
" Are the headphones connected?
" Are the speaker wires disconnected?
! CD player
Symptom
" Playback does not start.
" Is the disc loaded upside down?
" Playback stops in the middle or is
" Does the disc satisfy the standards?
not performed properly.
" Is the disc distorted or scratched?
" Playback sounds are skipped, or
" Is the unit located near excessive vibra-
stopped in the middle of a track.
tions?
" Is the disc very dirty?
" Has condensation formed inside the unit?
! Tuner
Symptom
" Radio makes unusual noise con-
" Is the unit placed near the TV or compu-
secutively.
ter?
" Is the FM aerial or AM loop aerial placed
properly? Move the AC power lead or the
unit away from the aerial if located near.
03/11/28
CD-DP900S(E)3.fm
Possible cause
Possible cause
Possible cause
TINSEA032AWZZ
Advertisement
Table of Contents
