Adjustments - RIDGID R4010 Operator's Manual

ADJUSTMENTS

WARNING:
Before performing any adjustment, make sure the
tool is unplugged from the power supply and the
switch is in the OFF position. Failure to heed this
warning could result in serious personal injury.
The saw has been adjusted at the factory for making very
accurate cuts. However, some of the components might
have been jarred out of alignment during shipping. Also,
over a period of time, readjustment will probably become
necessary due to wear.
Do not start any adjustments until you have checked with
a square and made test cuts to be sure adjustments are
needed.
TO SQUARE THE CUTTING WHEEL TO THE
TABLE
See Figure 34.
Do not loosen any screws for this adjustment until you have
checked with a square and made test cuts to be sure adjust-
ments are necessary. Once the screws are loosened, these
items must be reset.
 Unplug the saw.
 Remove the water tray.
 Using a hex key, loosen hex bolts on the left rail.
 Place a framing square against the fence and the flat part
of the wheel.
 Using the set screw to adjust, move the rail until the fence
is square with the cutting wheel.
 Tighten the hex bolts securely.
ADJUSTING TABLE ROLLERS
See Figure 35.
If the table doesn't slide smoothly, seems too loose on the
rails, moves side to side, or is visibly off track adjustments
may be required.
To adjust the upper table roller:
 Loosen the cam bolt nut.
 Turn bolt to adjust roller up or down.
NOTE: Only the center roller is adjustable. Do not attempt
to adjust the left or right rollers.
 Once the rollers are touching the rail, tighten the cam bolt
nut securely.
To adjust the lower table rollers:
 Loosen the cam bolt nut.
 Insert hex key through the hole in the left side of the table
and adjust bolt as needed.
 Once the rollers are touching the rail, tighten the cam bolt
nut securely. Repeat for each roller as required.
NOTE: Check that rollers are sliding properly after each
adjustment.
hex
KeY
fraMinG
sQuare
adJustinG uPPer taBle roller
caM
Bolt
nut
roller
adJustinG lower taBle rollers
caM
Bolt
nut
26 — English
set
screw
hole
roller
hex
KeY
hex
Bolts
Fig. 34
Fig. 35