RIDGID R4010 Operator's Manual page 15

ASSEMBLY
 Push the short clear tube of the T-connector assembly
over the connector on the back of the diverter valve (as
shown in figure 9). Attach the long clear tube (with the
check valve) to the submersible water pump and set the
pump in the bottom of the water tank. Secure tube with
hose clamps.
 Push back rubber boot on electrical cord and plug pump
into an outlet or extension cord. Pull boot over cord con-
nections to help keep water off the plug.
INSTALLING TH E WATER TRAY AND TRAY
ExTENSI ONS
See Figures 10 - 12.
 From the right side of the saw, place the water tray (drain
plug end to the left) on the lip at the bottom of the water
tray frame. Slide the water tray in under the sliding table.
 Standing at the back of the saw, hold the water tray exten-
sion at an angle. Tilt the tray and slip the guide between
the frame top and frame bottom.
 Once the extension slides into place, lower the water tray
extension until the tray tabs fit into the holes under water
tray frame.
 From the left side of the saw, slide the second (or side)
water tray extension into the slots on the back water tray
extension.
clear
connector
tuBe
ruBBer
Boot
clear
tuBe
water
inner leG
suPPlY
asseMBlY
ValVe
clear tuBe
with cleaninG
ValVe noZZle
asseMBlY
checK
ValVe
water
fill
line
cleaninG
noZZle
storaGe
Fig. 9
15 — English
water traY
fraMe
water
traY
water traY
extension
Fig. 10
water traY
fraMe
water traY
extension
Fig. 11
water traY
extension
Fig. 12