RIDGID R4010 Operator's Manual page 17

ASSEMBLY
CONNECTING THE GARDEN HOSE
See Figure 16
The water supply must come from a fresh water main. NEVER
turn the water supply on high (fully opened).
The water supply valve provides a convenient on/off for
adjusting the water flow onto the cutting wheel. When used
properly, the water supply valve adjusts the water flow to
the perfect, optimal rate.
 Uncoil the garden hose.
 With the water main faucet turned completely off, attach
the end of the garden hose to the water supply valve.
Tighten by hand.
TO CLOSE / OPEN THE WSUV™ WET SAW
UTILITY VEHICLE / LEG STAND
See Figures 17 - 19.
 Remove water tray, water tray extensions and the water
tank, and any workpieces from the tool. Store.
 Place the sliding table in the center of the frame and lock
the table in place.
 Lower the wheel and secure by locking the saw head in
place using the lock knob.
To close the leg stand:
 At the same time, step on the release lever, grasp the
grips, and lift the handles up and away from the body.
 Push the saw until the release lever clicks and locks into
place.
To move the leg stand:
 Holding the grips firmly, pull the handles toward you until
the leg stand and saw are balanced on the wheels.
 Push the saw to the desired location then either open
the leg stand for saw operation or store the saw in a dry
environment.
Garden
hose
Garden
hose
connector
Fig. 16
17 — English
release
leVer
Fig. 17
Fig. 18