RIDGID R4010 Operator's Manual page 14

ASSEMBLY
INSTALLING THE WATER TRAY FRAME
ASSEMBLY TO THE LEG STAND
See Figure 7.
 Lock the table stop by-pass by pulling up on the stop
and turning it until the slot in the center of the lock is
horizontal (left to right).
 To lock sliding table: Pull the sliding table to the front
of the frame. From under the right side of the table, align
the hole in the rail with the pin in the sliding table lock
lever. Push the pin into the rail locking the table.
 Slide the tubes on the water tray frame assembly into the
tubes on the leg stand.
 Insert short carriage bolts into holes and tighten securely
using lock nuts.
INSTALLING MOTOR HEAD ASSEMBLY TO
WATER TRAY FRAME
See Figure 8.
 Align the holes in the motor head assembly with the holes
on the side of the water tray frame.
 Insert short cap bolts. Finger tighten using nuts.
 Slide long cap bolts into sleeve. Insert into holes. Finger
tighten.
 Tighten all cap bolts using an 8 mm hex key.
INSTALLING CLEAR TUBES, CLEANING
NOZZLE, AND WATER PUMP TO THE SAW
See Figure 9.
NOTE: Hose clamps secure clear tubes to valves, connec-
tors, etc. To attach a hose clamp, squeeze the ends of the
clamp together then slide the clamp over one end of a short
clear tube. Once the tube has been attached to a valve, con-
nector, etc., squeeze the clamps ends together and slide the
clamp over the tube covering the connector.
 Grasp the diverter valve firmly then push the end of the
short clear tube over the left connector. Secure with a
hose clamp.
 Slip the tube onto the valve assembly in the saw arm by
pushing the tube over the connector. Secure with a hose
clamp. Attach the clear tube to leg stand using the tube
clips on top of the leg stand.
 Holding the diverter valve, connect the long clear tube
(with the cleaning nozzle) to the right side of the diverter
valve by pushing the tube over the connector. Secure
with a hose clamp. Store the nozzle in the cleaning nozzle
storage.
 Fill the water tank two-thirds full.
 Center the water tank on the lower brace of the leg stand
and push the tank firmly against the center brace until it
locks into place.
 Push clear tube of the T-connector assembly over the
garden hose attachment on the leg stand. Secure with a
hose clamp.
slidinG taBle
locK leVer
water
traY
fraMe
asseMBlY
short
carriaGe
Bolt
hex
nut
14 — English
locK
nut
sleeVe
water traY
fraMe
taBle stoP
BY-Pass
leG
stand
Fig. 7
Motor
head
asseMBlY
caP Bolt
(short)
caP Bolt
(lonG)
Fig. 8