Placing Paper In Trays - Toshiba ES9465 MFP Copying Manual

1.BEFORE USING EQUIPMENT
*9 If a finisher has been installed, the receiving tray of the equipment is not available for paper exiting, but the upper stacker of the Finisher and
the Saddle Stitch Finisher are used.
*10 Note that black streaks may appear on the edge of the printed sheets.
*11 If the Finisher or the Saddle Stitch Finisher has been installed, the receiving tray of the equipment is used for paper exiting. If the Inner Finisher
has been installed, the receiving tray of the finisher is used for paper exiting.
*12 Duplex copying is not available.
"LT format" is the standard size only for use in North America.
"K format" is a Chinese standard size.
Abbreviations for paper sizes: LT: Letter, LD: Ledger, LG: Legal, ST: Statement, COMP: Computer, SQ: Square
Unacceptable copy paper
Do not use the types of paper shown below. This could cause a paper misfeed.
Damp paper
Folded paper
Curled or creased paper
Paper whose surface is extremely smooth or rough
Do not use the types of paper shown below. This could cause an equipment malfunction.
Paper whose surface has had special treatment
Paper once printed with other copiers or printers
Precautions for storing copy paper
Make sure of the following when storing copy paper:
Wrap the paper in its wrapping to keep it free from dust.
Avoid direct sunlight.
Store in a damp-free space.
To prevent paper from being folded or bent, store it in a flat place.

Placing paper in trays

Follow the procedure below to place paper in the tray, Paper Feed Unit, Paper Feed Pedestal, or Additional Drawer
Module. For acceptable copy paper, see the following page:
P.11 "Acceptable copy paper"
1
Turn the power of this equipment ON.
2
Pull out a tray carefully until it comes to a stop.
When placing paper in the Paper Feed Unit of ES9455 MFP or the
tray, Paper Feed Pedestal, or Additional Drawer Module of ES9475
MFP Series, proceed to step 4.
1 BEFORE USING EQUIPMENT
Placing Paper 13