Hard Disk Upgrade - Everex StepNote XT5000T User Manual

Everex stepnote xt5000t: user manual
Hide thumbs Also See for StepNote XT5000T:
Table of Contents

Advertisement

To remove a memory module, push the locking tabs aside from the memory
module until the module pops up. Then, remove the memory module.
7.2

Hard Disk Upgrade

Your notebook computer offers one 2.5" format, 9.5mm height hard disk. If
the volume does not fit your need or it is crashed, you can upgrade it by
replacing with new hard disk. Please do the following steps to change it.
1.
Remove the screw and open the cover by lifting its upper side cover.
2.
Take out the hard disk from the compartment by finger carefully
3.
Remove the connector from the hard disk gently.
4.
Remove the crane screws located at each side of the hard disk.
5.
Rotate and tighten the crane screws to the new hard disk.
6.
Attach the connector to the new hard disk precisely.
7.
Place the hard disk back to the compartment.
8.
Cover the lid, then rotate and tighten the screws.
7
Using Options
117

Advertisement

Table of Contents
loading

This manual is also suitable for:

Stepnote xt5300tStepnote xt series

Table of Contents