Oki IP-7900-21 Advanced Operation Manual page 59

[Symptom C]
The ink does not match well with
l
the media.
(Media with low dot spread rate)
*1
Adjust the media advance compensation again.
*2
Note that the print speed differs depending on the mode selected.
(1) Decrease the all three heaters by 5°C.
* Before starting the print, ensure that the heater temperature was decreased to the
target temperature.
* With some media, the heater temperature increased would be effective.
(2) Set smart pass to a higher setting.
(3) Change the print mode to be slower.
(4) Use the proven media.
*1
*1*2
*1*2
59