Table of Contents
Advertisement
Print sample
8
To obtain the correction value:
Obtain the adjustment value by measuring the margin setting the reference value to 15 mm.
<Example>
The margin is 14 mm: The adjustment value is -1.0 mm.
The margin is 16 mm: The adjustment value is +1.0 mm.
9
# E D G E S E N S O R A D J U S T
# E X E C U T E >
10
# E D G E S E N S O R A D J U S T
# P O S A D J > + 0 . 0 m m
11
# E D G E S E N S O R A D J U S T
# P O S A D J [ + 0 . 0 m m
12
# E D G E S E N S O R A D J U S T
# P O S A D J [ + 0 . 5 m m
13
# E D G E S E N S O R A D J U S T
# P O S A D J > + 0 . 5 m m
100
IP-7900-20/21/7700-20/21 Advanced Operation Guide
15 mm
,
,
,
,
Judge the print results.
Measure the margin of the printing result with a ruler,
and obtain an difference between the measured
margin and the value (15 mm) shown in the
specifications.
If the difference is 0 mm, complate this procedure.
If not, follow the prcedure below to adjust the value.
Select [POS ADJ] with the
Press the
key.
Select the digit with the
value with the
,
key.
Press the
key.
The adjustment is complete.
,
key.
,
key, set the
key, and press the
Advertisement
Table of Contents
