Mazda 2004 RX-8 Owner's Manual page 15

J60E_8R65-EA-03C_Edition2.book Page 4 Saturday, April 26, 2003 1:48 PM
Essential Safety Equipment
Seats
(Manually operated seats)
To change the seatback angle, lean
forward slightly while raising the lever.
Then lean back to the desired position and
release the lever.
Lever
Make sure the lever returns to its original
position and the seatback is locked in
place by attempting to push it forward and
backward.
CAUTION
When returning a rear-reclined
seatback to its upright position, make
sure you support the seatback while
operating the seatback lever. If the
seatback is not supported, it will flip
forward suddenly and could cause
injury.
2-4
*Some models.
Form No. 8R65-EA-03C
(Electrically operated seats)
Change the seatback angle by pressing the
front or rear side of the reclining switch.
When the seatback is at the desired angle,
release the switch.
Switch
M Height Adjustment (Driver's
Seat)*
(Manually operated seats)
To raise the seat-bottom, pull up the lever.
Release the lever at the desired position.
To lower the seat-bottom, push down the
lever. Release the lever at the desired
position.
Up
Down
Lever