How To Remove The Sewing Table; When Replacing The Bobbin Thread - JUKI APW-895NE Instruction Manual

② Then pass needle thread in the order as shown in the figure below.
C
B
A
A
Periodically replace thread guide felt C. Sewing trouble due to rough motion of thread
during sewing can be prevented.

2. HOW TO REMOVE THE SEWING TABLE

CAUTION
:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.

(1) When replacing the bobbin thread

❷
A
B
A
A
B
Pass the needle thread in the illustrated order.
Left-hand side needle thread toward
B
Right-hand side needle thread toward
① Move the clamp foot to the rear end of its stroke.
② Insert your fingers into notches A in the bottom
of right- and left-hand sewing tables ❶ and ❷ ,
❶
and push up the sewing tables.
③ Move the tables in the direction of the arrow
keeping the above state, and you can see the
bobbin case.
Pin
④ After replacing the bobbin thread, return
the sewing tables in place by following the
above-mentioned steps of procedure in the
reverse order. Now, firmly set the sewing tables
on the throat plates and the pins.
− 15 −
B
A
A
B
the sewing machine
the sewing machine
At this time, move the sewing tables
so as not to allow the sewing tables to
come in contact with the needles.
A
B