Canon PIXMA mini260 Photo Printing Manual page 58

Cause
Printer detected ink out
condition of the following ink.
Replace the ink tank.
U170
The remaining level of the
following ink cannot be correctly
detected. Replace the ink tank.
U180
Print head is not installed.
Install the print head. / The type
of print head is incorrect.
Install the correct print head.
The ink absorber is almost full.
Press OK to continue printing.
Contact the service center.
The following ink tank cannot be
recognized.
U140
U150
56 Troubleshooting
Ink has run out. (The lamp on the ink tank flashes.)
Replace the ink tank and close the Printer Cover.
Printing under the current condition may damage the printer.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level. Press
and hold the Stop/Reset button for at least 5 seconds, and then
release it.
* With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that Canon
shall not be liable for any malfunction or trouble which may be
caused by continuation of printing under the ink out condition.
The remaining ink level cannot be correctly detected.
Replace the ink tank and close the Printer Cover.
Printing with an ink tank that was once empty may damage the
printer.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level. Press
and hold the Stop/Reset button for at least 5 seconds, and then
release it.
* With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that Canon
shall not be liable for any printer malfunction or damage caused
by refilled ink tank.
Follow the directions given in the Easy Setup Instructions (Setup
Sheet) to install the Print Head.
If the Print Head is already installed, remove the Print Head and
then reinstall it. If the error is not resolved, the Print Head may be
damaged. Contact your Canon Service representative.
The printer has a built-in ink absorber to hold the ink used during
Print Head Cleaning, for example.
This error message indicates that the ink absorber is nearly full.
Press the OK button to cancel the error so you can continue
printing.
However, because printing is disabled once the ink absorber
becomes completely full and until the ink absorber is replaced,
you are recommended to contact a Canon service representative
as early as possible (You will need to replace a particular part of
the printer).
The ink tank is not compatible with this printer. (The lamp on the
ink tank is off.)
Install an appropriate ink tank.
See "Replacing an Ink Tank" on page 47.
An Ink tank error has occurred. (The lamp on the ink tank is off.)
Replace the ink tank.
See "Replacing an Ink Tank" on page 47.
Action