Canon PIXMA mini260 Photo Printing Manual page 72

Canon pixma mini260: printing guide
Hide thumbs Also See for PIXMA mini260:
Table of Contents

Advertisement

Camera Error Message
Printer in use
No paper
Paper jam
The Paper Thickness Lever
position is incorrect.
Printer cover open
No printhead
Waste tank (ink absorber) full/
Ink absorber full
No Ink
Ink error
70
Troubleshooting
Images are being printed from the computer.
Wait until printing ends. The printer automatically starts printing the
images from the camera after completing the current printing.
If the printer is warming up, wait until warm-up ends. When it is
ready, the printer starts printing automatically.
Load the paper in the Auto Sheet Feeder, and select Continue
in the display on your camera.
Select Stop in the display on your camera to stop printing.
Remove the jammed paper, load new paper, and press the OK
button on the printer and retry printing.
Set the Paper Thickness Lever to the right. If paper is scratched,
set the Paper Thickness Lever to the left. Return the Paper
Thickness Lever to the right after printing.
Close the Printer Cover on the printer.
The Print Head is defective or not installed.
Install a Print Head according to the Easy Setup Instructions
(Setup Sheet).
If the Print Head has already been installed, remove the Print
Head and reinstall it. If the error still remains, the Print Head may
be defective. Contact the Canon service representative.
The printer has a built-in ink absorber to hold the ink used during
Print Head Cleaning, for example, This error message indicates
that the ink absorber is nearly full.
You can continue printing for a while by selecting Continue
the display on your camera.
However, because printing is disabled once the ink absorber
becomes completely full and until the ink absorber is replaced,
you are recommended to contact a Canon service representative
as early as possible (You will need to replace a particular part of
the printer).
An ink tank is not installed properly, or is out of ink.
Confirm the error message displayed on the LCD and take the
appropriate action to resolve the error.
An ink tank that was once empty is installed.
Replace the ink tank and close the Printer Cover.
Printing with an ink tank that was once empty may damage the
printer.
If you want to continue printing in this condition, you need to
release the function for detecting the remaining ink level. Press
and hold the Stop/Reset button for at least 5 seconds, and then
release it.
* With this operation, releasing the function for detecting the
remaining ink level is memorized. Please be advised that Canon
shall not be liable for any printer malfunction or damage caused
by refilled ink tank.
Try This
*1
*1
in

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pixma mini 260

Table of Contents