Gps - Icom F6400DS 11 Operating Manual

Previous view
6
MENU SCREEN
Functions (Continued)
Surveillance
Turns the Surveillance function ON or OFF.
When this function is ON, beeps are not heard and
the backlight and the Status indicator do not light,
even when a signal is received, or a key is pushed.
USB Mode Select
Selects the USB port mode.
• Data Transfer: Used for setting up the transceiver,
updating the firmware, or using the
PC control command.
• Card Reader: Reads the inserted card contents.
VOX
Turns the VOX function ON or OFF.
When this function is ON, the receive and transmit are
automatically switched by detecting the user's voice.
NOTE: To use the function, a headset* and a VOX
converter cable are required (user supplied).
*Bluetooth headset is also usable.
VOX Delay
Sets the VOX Delay.
The VOX Delay is the period of time the transceiver
continues transmitting after the user stops speaking,
and then the VOX switches to receive.
• Range: 0.5 ~ 3.0 seconds
NOTE: If you set the time too short, a pause in
a conversation may be regarded as the end of
conversation, and the transceiver will start receiving,
even as the conversation continues.
VOX Gain
Sets the VOX gain.
The VOX function automatically switches between
receive and transmit by detecting the user's voice.
• Range: 1 ~ 10
L Higher values make the VOX function more sensitive to
sounds.

GPS

GPS ON/OFF
Turns the GPS function ON or OFF.
When this function is ON, position data from the
internal GPS receiver (Portable) or external GPS
receiver (Mobile) is displayed in the "My Position"
screen.
My Position
Displays the transceiver's current position.
RX List
Displays the received call log that include position
data. Push [Up] or [Down] to select the log, then push
[OK].
TIP: The transceiver may receive the position data
with the Voice message, Status message, Message,
Call Alert, or Emergency call.
6-11