Icom F6400DS 11 Operating Manual page 140

Previous view
11
Bluetooth ® OPERATION
Turning ON the Bluetooth
D For the Portable Non-display types and Mobile Segment types (Continued)
Mobile:
Step 1: Entering the Bluetooth
1. Turn OFF the transceiver.
2. While holding down [F2] and [F3], turn ON the
transceiver. Continue holding down [F2] and [F3]
for about 3 seconds.
• 2 beeps sound.
Step 2: Entering the Pairing mode
L See the Bluetooth ® device's instruction manual for
details.
Step 3: Turning ON the Bluetooth
3. After the headset has entered the Pairing mode,
hold down [F1] for 1 second to enter the Set
mode.
4. Push [F2] or [F3] to select "b0."
5. Push [Up] to turn ON the Bluetooth
• The transceiver automatically enters the Pairing mode,
and begins searching for a Bluetooth
• While searching, the status indicator quickly blinks
blue.
L If the status indicator does not blink after pushing
[Up], the transceiver has not entered the Bluetooth
Set mode. In that case, do steps 1 and 2 again.
L If the transceiver has been paired with a Bluetooth
headset before, the transceiver does not start
searching. In that case, the transceiver and the
headset are automatically connected.
Step 4: Pairing with a headset
When a headset is found, the transceiver pairs with it.
• After the transceiver and the headset pairing has
succeeded, the Status indicator slowly blinks blue 3 times.
In that case, the connection to the headset has also
succeeded.
L T hetransceiversearchesforaheadsetfirst.After
searching for a headset, the transceiver will start
searching for a data device. To skip searching for a data
device, push [PTT] on the headset.
L If the Bluetooth ® connection fails, the Status indicator
slowly blinks red 3 times. To search for a headset again,
push [Down] to turn OFF the Bluetooth
push [Up] to turn it ON again.
® function
® Set mode
(Transceiver)
(Bluetooth ® device)
function
®
(Transceiver)
® function.
® headset.
(Transceiver)
® function, then
Step 5: Pairing with a data device
1. When a data device is found, the transceiver pairs
with it.
• After the transceiver and the data device pairing has
succeeded, the Status indicator slowly blinks blue 3
times. In that case, connection to the data device has
also succeeded.
L If the Bluetooth
slowly blinks red 3 times. To search for a PC again,
push [Down] to turn OFF the Bluetooth
then push [Up] to turn it ON again. The transceiver
automatically tries to connect.
2. Hold down [F1] for 1 second to exit the Set mode.
3. Turn OFF the transceiver, then turn it ON again to
normally operate the transceiver.
®
TIP: To turn OFF the Bluetooth
[Down] when "b0" is selected in the Set mode.
®
11-5
® connection fails, the Status indicator
[Up]
Power key
F1 F2 F3
[F1] [F2] [F3] [Down]
® function, push
(Transceiver)
® function,