Table of Contents
Advertisement
Steps
1.
Disconnect any cables connected to the expansion card or expansion card riser.
2.
To remove the expansion card, lift the expansion-card latch.
3.
Grasp the expansion card by its edges and remove it from the expansion-card connector on the
riser.
4.
If you are removing the card permanently, install a metal filler bracket over the empty expansion slot
opening and close the expansion-card latch.
NOTE: Install a filler bracket over an empty expansion slot to maintain Federal Communications
Commission (FCC) certification of the system. The brackets also keep dust and dirt out of the
system and aid in proper cooling and airflow inside the system.
Figure 21. Removing and installing the expansion card
1.
expansion connector
3.
expansion-card
Next steps
Follow the procedure listed in the After working inside your system section.
Related video
http://www.Dell.com/XCSeries/XC630/PCI
Installing an expansion card
Prerequisites
1.
Ensure that you read the
2.
Follow the procedure listed in
64
Safety
instructions.
Before working inside your
2.
expansion card latch
4.
expansion-card latch
system.
Advertisement
Table of Contents
Troubleshooting
