Table of Contents
Advertisement
Setup
* = Optional Connections
TOP FRONT
BOTTOM FRONT
1.1
Jumpers
See
Figure 4
for jumper locations.
VSEL— This jumper allows output voltage selection of either 3.3 V or 5 V. See the
MODE— This jumper allows the selection of either AUTO mode or FPWM mode. In addition, by removing
this jumper and supplying a clock signal to the SYNC/MODE test point, the device can by
synchronized to an external clock.
EN— This jumper turns the device on or off. In addition, by removing this jumper and supplying a signal
to the EN test point, the device can be controlled externally.
4
LM63625QDRREVM EVM User's Guide
(+)
INPUT
SUPPLY
VINEMI
VIS
(+)
(-)
CM Choke
Input *
Input
(+)
Voltage
DMM
Figure 3. EVM Card Edge Connections
VOUT Selection
Jumper
Mode Selection
Jumper
Figure 4. Jumper Locations
Copyright © 2020, Texas Instruments Incorporated
(-) (-)
LOAD
GND
(-)
Enable
Jumper
(+)
VOUT
VOS
Output
(+)
(-)
Voltage
DMM
Section 2
for details.
SNVU702 – February 2020
Submit Documentation Feedback
www.ti.com
Advertisement
Table of Contents
