Figure 1-2. Evm Card Edge Connections; Figure 1-3. Jumper Locations - Texas Instruments LM63635DNEVM User Manual

Setup
* = Optional Connections
TOP FRONT
BOTTOM FRONT
1.1 Jumpers
See Figure 1-3 for jumper locations.
MODE This jumper allows the selection of either AUTO mode or FPWM mode. In addition, by removing this
jumper and supplying a clock signal to the SYNC/MODE test point, the device can by synchronized to
an external clock.
EN This jumper turns the device on or off. In addition, by removing this jumper and supplying a signal to the
EN test point, the device can be controlled externally.
4 LM63635DNEVM EVM User's Guide
(+)
INPUT
SUPPLY
VINEMI
VIS
(+) (-)
CM Choke
Input *
Input
(+) (-)
Voltage
DMM

Figure 1-2. EVM Card Edge Connections

Mode Selec on
EN Control
Jumper

Figure 1-3. Jumper Locations

Copyright © 2022 Texas Instruments Incorporated
(-) (-) (+)
LOAD
GND VOUT
Output
(-)
Voltage
DMM
Jumper
www.ti.com
VOS
(+)
SNVU767 – MARCH 2022
Submit Document Feedback