Installation Instructions; Positioning The Tumble Dryer - Asko TLS752 XXL Operating Instructions Manual

Installation Instructions

Caution!
Risk of Fire
Dryer installation must be performed by a
qualified installer.
• Install the dryer according to the
manufacturer's instructions and local
codes.
• Do not install a dryer with flexible plastic
venting materials. If flexible metal (foil
type) duct is installed, it must be UL
certified for use with clothes dryers.
Flexible venting materials are known to
collapse, be easily crushed, and trap
lint. These conditions will obstruct dryer
airflow and increase the risk of fire.
• To reduce the risk of severe injury or
death, follow all installation instructions.
• Save these instructions.
The following instructions will guide you
through the initial steps of setting up your
dryer.
Please note that every section of this
manual provides important information
regarding the preparation and use of your
dryer. It is important that you review this
entire manual before proceeding with any
installation or use.
More detailed instructions concerning
electrical connections, gas connections, and
exhaust requirements are provided in other
parts of this manual.
26
Step 1. Positioning the tumble
dryer
Choose a location with a solid floor for your
dryer.
Place the dryer in the desired location and
please make sure that it has the required
clearances shown below.
40 3/8"
(102.5cm)
(68.6cm)
• Most installations require a minimum 6"
(15.2 cm) clearance behind the dryer for
the exhaust vent with elbow.
Note!
Leveling legs should be secured.
All four legs should be firmly placed on a
solid and even floor.
If dryer is not level, laundry may not tumble
properly and sensor will not detect humidity
information accurately.
When leveling, please be cautious not to
injure your fingers and toes.
If you install the dryer on the optional
pedestal, it is necessary to level with the
pedestal leveling legs.
Customer Care Center
1-800-898-1879
www.askousa.com
(132cm)
32"
(81.2cm)
27"
52"