Electrical Plug Connections; Preparation Of The Dryer; Confirming Heat Source Operation - Asko TLS752 XXL Operating Instructions Manual

Installation Instructions
Step 4. Electrical plug connections
The following instructions apply to
U.S. electrical dryer model:
The following steps are several warnings
and instructions concerning making the
electrical connection for electric dryers.
More detailed information concerning
the electrical connection is provided in
the manual section entitled Electrical
Requirements for Electric Dryer.
It is important that you thoroughly review
that section and the remainder of this
manual, before taking any steps to install or
use this dryer.
1. Use only a new U.L. listed No. 10
(copper wire only) three or four
conductor power supply cord kit rated
240 Volts (minimum) 30 amp and
labeled as suitable for use in a dryer.
2. A four-wire cord is required for
manufactured (mobile) home
installations and where local codes do
not allow grounding of this appliance
through neutral.
3. Electrical Plug Connections. For
additional instruction on connecting
the dryer to an electrical power source,
please refer to this manual's section on
Electrical Requirements for an Electric
Dryer.
Caution!
• Use a new U.L. listed 30 amp power
supply cord.
• Use a U.L. approved strain relief.
• Disconnect power before making
electrical connections.
• Connect the neutral wire (white or center
wire) to the center terminal.
• The ground wire (green or bare wire)
must be connected to green ground
connector.
32
• Securely tighten all electrical
connections
• See the installation instructions for
complete instructions.
• Failure to do so may result in fire or
electrical shock.
Step 5. Preparation of the dryer
Prior to the first use of this appliance, use
all purpose cleaning products or a solution
of detergent and water, and a damp
cloth to remove any dirt or dust that has
accumulated inside the dryer.
Plug-in your dryer after reviewing the
following parts on your dryer's Electrical
Requirements.
Step 6. Confirming heat source
operation
Gas Dryers:
Close the door to the dryer drum/drying
compartment. After completing all steps
in this manual for proper installation, start
the dryer on a heated dry setting. After the
dryer starts, the igniter will glow red and the
main burner will ignite.
Caution!
If all air is not purged from the gas line,
the gas igniter may go off before the gas
and the main burner have ignited. If this
happens, the igniter will re-attempt gas
ignition after approximately two minutes.
Electric Dryers:
Close the door to the dryer drum/drying
compartment. After completing all steps in
this manual for proper installation, start the
dryer on a heated dry setting. The exhaust
air or the exhaust pipe should be warm
after the dryer has been operating for three
minutes.
Customer Care Center
1-800-898-1879
www.askousa.com