Table of Contents
Advertisement
Innovative Hearth Products
DRT3500-C Series Direct-Vent Gas Fireplaces
Installing Non-Combustible Front Fireboard Standoff and Header Shield
5.
A non-combustible standoff board is provided with the fireplace to prevent overlap of drywall or other material of portions of the
fireplace that may be prone to the buildup of heat. It is supported by a middle bracket and two side brackets.
Separate and note metal side
(2) and center (1) brackets.
Screw
Step 2: Remove screw holding standoff to firebox, bend to
4" tall (as seen above) and attach screw.
20
Step 1: Remove two screws from the top and side of the unit. Bend the side bracket securing tab
over the edge of the unit and secure. Secure bracket to the top through the clearance screw hole.
Standoffs
Step 3: Install the header shield by slid-
ing it into the slot in the standoffs.
Header
Shield
Installation
900960-00D, 04/2020
Step 4: Fireboard standoff can
be secured to the capture screw
holes.
Advertisement
Table of Contents
