Innovative Hearth Products
DRT3500-C Series Direct-Vent Gas Fireplaces
Elbow Heat Shield
If using a 90 degree elbow directly off fireplace, the elbow shield is required. Install per instructions in Figure 17.
Figure 17 - Elbow Heat Shield
STEP 1. Locate the two (2) flat elbow
shields.
STEP 4. Attach the two (2) shields to the fireplace.
24
STEP 2. Bend the three (3) tabs 90
degrees as shown below.
STEP 5. Fold down tab to support rear of shield.
900960-00D, 04/2020
STEP 3. Attach the two (2) shields, as
shown, with screws.
Installation