Table of Contents
Advertisement
Innovative Hearth Products
DRT3500-C Series Direct-Vent Gas Fireplaces
Installing the DRT3500-C 35 Series Oak Log Set
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log placement is
critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the flames. Follow the log placement
instructions precisely.
NOTE: Do not cover the burner ports.
Table 30 - Oak Log Set
I.D. No.
Description
1
Rear Log
2
Bottom Left Log
3
Front Right Log
4
Twig Log
5
Bottom Right Log
Catalog number for the
entire log set: See Page 73.
1. If necessary, remove the glass door (Pages 63-64). Locate the placement tabs (Figure 44).
2. Bend up the log placement tabs (Figure 44).
3. Tear the glowing embers into dime size pieces. Place glowing embers as shown in Figure 43.
Figure 43 - Place glowing embers (rockwool)
4. Install rear log on two rear tabs (b & d) WW(Figure 44 and 45).
Figure 44 - Locate the log placement tabs/points
BEND UP TABS
Tab & Dam
Log #2
b
a
Air Dam
58
2
3
Tabs for
Log #1
d
Grate
c
e
Log #3
5
4
1
Do NOT place embers on or close to large
ports or the pilot area as seen here (circled).
NOTE: Enough glowing ember material is provided for several applications.
For best glowing effect, replace the ember material annually.
Figure 45 - Install Rear Log (1)
Pin for
twig #4
Grate
Log #5
f
Fits over Tab "b"
(Figure 44)
Bottom View
1
4
2
1
Fits over Tab "d"
(Figure 44)
Front View
Operation
900960-00D, 04/2020
3
5
Landing for
log #3
Advertisement
Table of Contents
