Download Print this page

Audio Technica System 9 Installation And Operation Manual

Vhf wireless system

Advertisement

Quick Links

System 9
VHF Wireless System
Installation and Operation
1
2
3
4
RF
PEAK
CHANNEL
ATW-901a/G
Guitar System
ATW-901a/H
Headworn Microphone System
ATW-901a/L
Lavalier Microphone System
ATW-902a
Handheld Microphone System

Advertisement

loading

Summary of Contents for Audio Technica System 9

  • Page 1 System 9 VHF Wireless System Installation and Operation PEAK CHANNEL ATW-901a/G Guitar System ATW-901a/H Headworn Microphone System ATW-901a/L Lavalier Microphone System ATW-902a Handheld Microphone System...
  • Page 2: Receiver Installation

    System 9 Installation and Operation This device complies with part 15 of the FCC Rules. Operation is subject Because System 9 packaging is designed to hold all versions to the condition that this device does not cause harmful interference. of the system, some compartments in the carton may be intentionally left empty.
  • Page 3: Receiver Controls And Functions

    System 9 Installation and Operation Receiver Controls and Functions CHANNEL PEAK CHANNEL Figure A — Front Panel Controls and Functions 1. ANTENNAS: Position the “signal” antenna (1a) and CHANNEL “ground” antenna (1b) as shown to the right and above right. Fully extend both antennas by pulling on the endcaps.
  • Page 4 System 9 Installation and Operation Transmitter Setup Controls and Functions Battery Selection and Installation Switch Conf iguration for Channel Selection Two alkaline AA batteries are recommended. When inserting the battery, CHANNEL 1 CHANNEL 2 CHANNEL 3 CHANNEL 4 observe correct polarity as marked inside the battery compartment.
  • Page 5 System 9 Installation and Operation UniPak ® Transmitter Battery Installation Figure D — UniPak ® Transmitter 1. Slide off the battery cover as shown in Figure D. Switch Conf iguration for Channel Selection 2. Carefully insert two fresh AA alkaline batteries, observing polarity CHANNEL 1 CHANNEL 2 CHANNEL 3 CHANNEL 4 markings.
  • Page 6: System Operation

    System 9 Installation and Operation System Operation Adjusting Input Level - Handheld Transmitter Unscrew the lower body cover and slide it off, exposing the screwdriver and "LEVEL" (Gain Trimmer) control (Fig. C). Remove the screwdriver from its clip. Gently turn the "LEVEL" control to its full clockwise level before starting up the wireless system.
  • Page 7 System 9 Installation and Operation System Operating Frequencies RF Interference Please note that wireless frequencies are shared with other radio ser- vices. According to Federal Communications Commission regulations, System Operating Frequencies “Wireless microphone operations are unprotected from interference Each transmitter/receiver system operates on a choice of four switch- from other licensed operations within the band.
  • Page 8 System 9 Installation and Operation Audio-Technica Corporation (Headquarters) 2-46-1 Nishi-naruse, Machida, Tokyo 194-8666, Japan Audio-Technica U.S., Inc. 1221 Commerce Drive, Stow, Ohio 44224, USA www.audio-technica.com © 2017 Audio-Technica Corporation P52391-01...

This manual is also suitable for:

Atw-r900aAtw-901a/gAtw-901a/hAtw-901a/lAtw-902a