Idrac Settings Utility; Device Settings; Dell Lifecycle Controller; Embedded System Management - Dell E02B005 Installation And Service Manual

Table of Contents

Advertisement

iDRAC Settings utility

The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI. You can enable or disable various
iDRAC parameters by using the iDRAC settings utility.
NOTE:
Accessing some of the features on the iDRAC settings utility needs the iDRAC Enterprise License upgrade.
For more information about using iDRAC, see Dell Integrated Dell Remote Access Controller User's Guide at
poweredgemanuals.

Device Settings

Device Settings enables you to configure the below device parameters:
Controller Configuration Utility
Embedded NIC Port1-X Configuration
NICs in slotX, Port1-X Configuration
BOSS Card configuration

Dell Lifecycle Controller

Dell Lifecycle Controller (LC) provides advanced embedded systems management capabilities including system deployment, configuration,
update, maintenance, and diagnosis. LC is delivered as part of the iDRAC out-of-band solution and Dell system embedded Unified
Extensible Firmware Interface (UEFI) applications.

Embedded system management

The Dell Lifecycle Controller provides advanced embedded system management throughout the lifecycle of the system. The Dell Lifecycle
Controller can be started during the boot sequence and can function independently of the operating system.
NOTE:
Certain platform configurations may not support the full set of features provided by the Dell Lifecycle Controller.
For more information about setting up the Dell Lifecycle Controller, configuring hardware and firmware, and deploying the operating
system, see the Dell Lifecycle Controller documentation at www.dell.com/poweredgemanuals.

Boot Manager

The Boot Manager screen enables you to select boot options and diagnostic utilities.

Viewing Boot Manager

About this task
To enter Boot Manager:
Steps
1. Power on, or restart your system.
2. Press F11 when you see the following message:
F11 = Boot Manager
If your operating system begins to load before you press F11, allow the system to complete the booting, and then restart your system
and try again.
Pre-operating system management applications
www.dell.com/
43

Advertisement

Table of Contents
loading

This manual is also suitable for:

E02bEmc poweredge fc640

Table of Contents