Figure 29. Removing the processor and heat sink module
Next steps
1.
Install the
PHM.
Removing the processor from the processor and heat sink
module
Prerequisites
WARNING:
The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat
sink to cool before removing it.
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove the air
shroud.
4.
Remove the processor and heat sink
Steps
1. Insert a flat blade screwdriver into the release slot marked with a yellow label. Rotate (do not pry) the screwdriver to break the
thermal paste seal.
2. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
68
Installing and removing system components
Safety instructions
on page 45.
Before working inside your system
module.
on page 45.