Dell E02B005 Installation And Service Manual page 94

Figure 58. Installing the system board
3. Align the USB connectors with the slots on the front of the system until the connectors engage with the slots.
4. Lower the system board and install the screws to secure the system board to the system, by using Hex nut driver-5 mm and Phillips
#2 screwdrivers.
Next steps
1. Replace the following:
a. TPM
b. Internal USB key
c. micro SD vFlash card
d. IDSDM
e. Network Daughter Card
f. PCIe mezzanine card(s)
g. Storage controller card
h. Drive cage
i. Drive backplane
j. Drives
NOTE: Ensure that you reinstall the drives in their original locations.
k. Air shroud
l. Memory modules
m. Processor(s) and heat sink(s)
2. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable
securing bracket.
3. Remove the plastic I/O connector cover from the back of the system.
4. Follow the procedure listed in the
5. Ensure that you:
94 Installing and removing system components
After working inside your system.