Information on the display panel
Display
The door cannot be
locked, please open
the door again, then
close it and select
"start/pause".
Please re-fill
i-DOS i/w,
i-DOS w container
i-DOS i/w,
i-DOS w error;
deactivate
i-DOS i/w,
i-DOS w
Please close
detergent drawer.
Please open tap
Please clean pump
Pause: Reload is not
possible
Door cannot be
unlocked: Water
level or temperature
is too high
AquaStop has been
activated!
Please call customer
service
Auto power-off in ...
seconds,
Water cooling
Other displays
Error E: XXX
48
Cause/Remedy
– Washing may be caught. Please open and close washing ma-
chine door again and select Avvio/Pausa (Start/Pause) A.
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
Level i-DOS container below minimum. Top up ~ Page 33
Set i-DOS i/w, i-DOS w to off.
Call customer service. Appliance can continue to be operated with
manual dosage. ~ Page 35
Push in detergent drawer correctly. ~ Page 34
– Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 46
– Drain pump blocked. Clean the drain pump. ~ Page 44
– The water drainage pipe/drain hose is blocked. Clean the drain-
age hose on the siphon. ~ Page 45
Water level or temperature is too high.
Select Avvio/Pausa (Start/Pause) A to continue the programme.
Water level or temperature is too high.
Select Avvio/Pausa (Start/Pause) A to continue the programme.
not applicable without AquaStop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 39
Appliance automatically switches off after ... seconds if it is not op-
erated for a prolonged period. In order to cancel the programme,
press any button. ~ Page 39
To protect the wastewater pipes, the hot detergent solution is
cooled before being drained.
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 51