Table of Contents
Advertisement
Faults, what to do?
Faults
Water is running out.
Water not flowing in.
Dispenser is empty
and fill level display
is not flashing.
Wrong detergent/
softener has been
poured into
dispenser.
Detergent/softener
congealed in the
dispensers.
Washing machine
door cannot
be opened.
Programme does
not start.
Detergent solution is
not drained.
Water not visible in
the drum.
Spin result not
satisfactory.
Washing wet/too
damp.
Spin cycle activated
several times.
Residual water in the
dispenser for care
product.
Cause/Remedy
– Correctly attach/replace drainage hose.
– Tighten screw-fitting on the supply hose.
– Avvio/Pausa (Start/Pause) A not selected?
– Tap not open?
– Filter blocked? Clean the filter. ~ Page 46
– Supply hose kinked or jammed?
– Drawer cover/rear drawer plug dirty? Cleaning ~ Page 42
– Detergent drawer not inserted correctly? Insert correctly.
~ Page 34
Dispensers:
1. Drain and clean dispensers.
2. Refill dispensers. ~ Page 33
Clean and refill dispensers.
– Safety function active. Stop programme?
– Rinse Hold
(without final spin) selected? ~ Page 20
$
– Can be opened via emergency release only? ~ Page 47
– Avvio/Pausa (Start/Pause) A or Fine fra (Finished in) time
selected?
– Door closed?
– Childlock active? Deactivate. ~ Page 18
– Rinse Hold
(without final spin) selected? ~ Page 20
$
– Clean the drain pump. ~ Page 44
– Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
– Not a fault – unbalanced load detection system has stopped the
spin cycle, washing unevenly distributed.
Distribute small and large items of washing in the drum.
–
Less Ironing selected? ~ Page 31
p
– Too low speed selected?
Not a fault – unbalanced load detection system adjusts imbalance.
– Not a fault – effect of the care product not impaired.
– If required, clean insert.
49
Advertisement
Table of Contents
