Using The Belt Clip - Datamax OC-3 Series User Manual

OC-3 SERIES OF PRINTERS USER'S GUIDE

Using the belt clip

Install the belt clip as follows:
1. Turn the printer so that its back faces you and the belt clip
socket is up, as shown in Figure 26.
2. Place the belt clip over the belt clip socket such that the flat
side of the belt clip swivel matches the flat side of the belt
clip socket (Figure 27).
3. Press the belt clip onto the printer until the swivel is fully
seated into the socket.
Belt clip socket
Figure 26
4. Rotate the belt clip 180 degrees to lock it into place (Figure
28 and Figure 29).
Figure 28
Reverse the above steps to remove the belt clip.
Belt clip swivel
Figure 27
Figure 29
12